![]() ![]() Serial.print(" size: ") Serial.println(ts.points.size) Serial.print(" y: ") Serial.print(ts.points.y) ![]() Serial.print(" x: ") Serial.print(ts.points.x) Serial.print("Touch ") Serial.print(i + 1) Serial.print(": ") TAMC_GT911 ts = TAMC_GT911(I2C_SDA_PIN, I2C_SCL_PIN, TOUCH_INT, TOUCH_RST, max(TOUCH_MAP_X1, TOUCH_MAP_X2), max(TOUCH_MAP_Y1, TOUCH_MAP_Y2)) We’ll use ArduinoGFX and configure the I/O pins as follows: The display relies on parallel RGB565 and SPI interfaces, and it’s supported by the ArduinoGFX library or the LovyanGFX library. The ESP32-S3 4-inch display board can be programmed with either Arduino or PlatformIO, and we’ll use the demo code provided by Makerfabs on GitHub for this review. Programming the Matouch_ESP32-S3 demo kit with Arduino/PlatformIO We can also peel the film on the adhesive paper on the speaker to attach it to the back of the frame. We can mount the ESP32-S3 4-inch Display board to the 3D-printed frame with the provided spacers, bolts, and nuts. The kit also comes with a speaker attached to the main board, a 3D printed frame/holder, a microSD card, a USB Type-C cable, and a screw set. The “Mabee TVOC and eCO2 SGP30 & Temperature and Humidity SHT31” module, which as its name implies, combines an SGP30 TVOC and eCO2 sensor (I2C address: 0x58) and an SHT31 temperature and humidity sensor (I2C address: 0x44), and operates at 3.3V. Temperature measurement range – -40☌~300☌, ☑.5☌ resolution.IR Thermal Sensor Array 32×24 (MLX90640).The Mabee MLX90640 thermal camera sensor with the following specifications: Expansion – 2x Mabee interfaces: 1x I2C 1xGPIO.USB – Dual USB Type-C (one for USB-to-UART and one for native USB) USB to UART Chip: CP2104.5 Points Touch, Capacitive via GT911 touch panel driver.4.0-inch IPS display with 480×480 resolution, 50+ FPS RGB 5/6/5+ SPI interface using ST7701S controller.Controller – ESP32-S3-WROOM-1, PCB Antenna, 16MB Flash, 8MB PSRAM, ESP32-S3-WROOM-1-N16R8.The mainboard of the MaTouch_ ESP32-S3 4-inch Display with the following specifications: When we unpack the box, we will find the device as in the picture, consisting of the following items: air quality monitors, or patient screening devices MaTouch_ESP32-S3 4-inch display demo kit unboxing It can be used to make various projects such as electronic photo frames. Makerfabs MaTouch_ESP32-S3 4-inch Display Demo Kit is an ESP32-S3 development board with a 4-inch touchscreen display, a TVOC sensor, and a thermal camera. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |